[ros-kernel] serial mouse driver patch = NOK

[Gge]

Filip Navara wrote:

> Hi Gerard!
>
> I think the problem is the enabling of mouse detection on COM2.  :(((
> Can you try it with commented out #define SERMOUSE_COM2_SUPPORT at top 
> of the sermouse.c file?
>
> Thanks,
> Filip
>
> Gge wrote:
>
>> Filip Navara wrote:
>>
>>> I have applied few changes from the supplied patch. Here is a list 
>>> of what was applied
>>> - Some of the formating changes (TABs/spaces)
>>> - Don't set 'Output Line 2' bit while power-uping the mouse during 
>>> initalization
>>> - Restore 'Line Control' register at the end of mouse detection.
>>> - Wait only 150000 millisecons (instead of 500000) for mouse power 
>>> down.
>>>
>>> Additionaly I enabled the detecting of mouse on COM2 by default. The 
>>> part of the patch for calling detection on COM1/COM2 port was wrong, 
>>> because there can be two mice on both port. Also removing the 
>>> SERMOUSE_COM[12]_SUPPORT defines isn't recommened yet, because the 
>>> (old) mouse detection routine collide with kernel debugging over 
>>> serial port.
>>>
>>> Can the users/developers with serial mouse test it now?
>>>
>>> Regards, Filip
>>>
>>> P.S. To Logan_V8_TT: I would be very interested if the new version 
>>> works with your mouse or not. If you can, please let me know.
>>>
>>>
>> Filip,
>>
>>
>> I compiled the new sermouse.sys driver and ran it in real hardware..
>> The serial mouse is connected on COM1 and DebugPort on Com2 ( this is 
>> my current configuration which is working ok)
>> The debug messages  stopped to be displayed  during the sermouse 
>> driver initialization as indicated in the attached  debug traces
>> The ros init  however continued upto the Desktop screen .
>> The mouse  cursor is displayed but is not moving at all .
>>
>> Note ;  I have not made the test  with the mouse connected to com2  
>> because it is supposed to work on com1 as well
>>
>> A confirmation is needed from another user/developper .
>>
>> Best regards
>> Gerard
>>
>>
>>
>> ======================================================
>> DriverBase for \SystemRoot\system32\drivers\serial.sys: cde69000
>> (dbg/kdb_stabs.c:848) Loading driver 
>> \SystemRoot\system32\drivers\serial.sys sym
>> bols (driver @ cde69000)
>> Serial Driver 0.0.2
>> DriverBase for \SystemRoot\system32\drivers\sermouse.sys: cde7f000
>> (dbg/kdb_stabs.c:848) Loading driver 
>> \SystemRoot\system32\drivers\sermouse.sys s
>> ymbols (driver @ cde7f000)
>> Serial Mouse Driver 0.0.9
>> Trying to find mouse on COM1
>> Microsoft Mouse with 3-buttons detected
>>
>> End of Debug Messages   !!!
>> ------------------------------------------------------------------------------------- 
>>
>>
> Filip ,


After commented out  SERMOUSE_COM[12]_SUPPORT in sermouce.c file  and 
recompiled , I made again the test .
1) Ros boot is OK now  and does not stopped at the sermouse.sys 
intialization.
2) Mouse is still  not moving on the desktop.

Regards
Gerard