Page 1 of 1

Re: Using serial ports for more than debug

PostPosted: Tue Jun 18, 2013 2:10 am
by pbreneman
I just tried the 0.3.15 release and both ports work as long as I leave the cables connected! If I disconnect the cable to either port they then fail. I'll try to do more testing but this looks much better than the last time I tested. Here is the program I'm using (2 copies of):
http://www.CtrlTerm.com

Re: Using serial ports for more than debug

PostPosted: Tue Jun 18, 2013 11:40 pm
by pbreneman
I see that this (long) message thread was broken into two parts. You might check out the two forum links on this page that will take you to the original messages I left in 2011:
http://www.turbocontrol.com/reactos.htm