[ros-kernel] install problem

[Hartmut Birr]

Hi,

I've a problem to install ros on my test computer. The installation (usetup)
works, but creates wrong entries in freeldr.ini for ros on the second disk.
The configuration is:

primary ide master:      Seagate ST36531A
primary ide slave:       Iomega ZIP 250

secondary ide master:    Yamaha CDRW4416E 
secondary ide slave:     -

SCSI controller SYM875:	 IBM DDYS-T09170N

I'm using a modified scsiport driver and setupldr to load the driver for the
scsi controller. Usetup creates for the second disk entries like this:

SystemPath=multi(0)disk(0)rdisk(2)partition(1)\ReactOS

The rdisk number is one too much. I think that isn't a problem of the scsi
controller. It seems that usetup interprets the ZIP drive as disk. Usetup
shows also the extended partition on the second disk. Output from usetup:

6197 MB  Harddisk 0 (port=0, Bus=0, Id=0) on atapi

  C:  FAT                               1028 MB
  D:  NTFS                              1028 MB
  E:  NTFS                              2047 MB
  F:  FAT32                             1028 MB
      Unpartitioned space               1067 MB

8746 MB   Harddisk 2 (port=2, Bus=0, Id=6) on trm390w

  --  Type 15                           8738 MB
      Unpartitioned space               8001 kB
  G:  FAT                               1004 MB
  H:  FAT32                             2000 MB
  I:  NTFS                              2000 MB
      Unpartitioned space               3734 MB

- Hartmut